Extend the Lifespan and Maintain the Efficiency of Your Dryer With 7 Tips
August 5, 2016
5 Causes of a Slow Drying Cycle
August 17, 2016

Are your dishes not coming out clean after a cycle in your dishwasher? Wondering why everything is still so dirty after a two-hour cycle? Perhaps you are not loading your dishwasher correctly. Try these seven tips to load your dishwasher correctly and see if it resolves your problem before calling for appliance repair in Hamilton.

1.) Big on Bottom, Small on top.

The most common things that are placed in the washers are plates. Make sure that they are facing the center, going inwards, not outwards. This helps because the tubes and jets rotating water and detergent spray out towards the center and then all around. Make sure the dishes do not touch, as the stream will not penetrate through tight cracks.

2.) Place things where water can reach it.

Your cups and bowls should be placed downwards to where the water streams upwards via the spinning arms. Your cups and bowls shouldn’t be collecting that dirty water and soap. Also, make sure to stack them on a slight incline. That way you can get the most room out of your washer. That means more dishes in the wash, less for you to hand wash.

3.) Spaced and upwards.

Cutlery should be facing upwards. The parts that have most contact with your mouth should be what is exposed. Knives are advised to be hand washed since the heat will dull the edge. Make sure that your silverware are evenly spaced out. Nothing is more unwelcoming than a pasta caked fork.

4.) Heated plastic.

Tupperware should be placed on the top rack of your dishwasher. However, it is advised that, unless it’s guaranteed heat resistant, you should hand wash Tupperware to prevent them from warping from the intense heat of your appliance.

5.) Don’t overcrowd your washer.

The more space you have for water to travel around the appliance, the better. Try to wash your pots and pans by hand. If you must pack your pots into the washer, face them towards the bottom, and place them on the bottom rack.

6.) Check for blocks.

Take the spinner and nudge it to spin in a full circle. If anything hits the dish spinner, move the item blocking its path. It is vital to have nothing block the spinners or the jets.

7.) Scrape that food off.

Yes. It is a dishwasher, but the appliance is not meant to scrape off that melted cheese, caked on sauce, or the rest of your mashed potatoes. Make sure to scrape your dishes off thoroughly before placing them into the washer. You can make the process easier by soaking them in the sink for a few minutes before loading them into the washer.

Are your dishes still coming out greasy and dirty? For a dishwasher repair in Hamilton, call Hamilton Appliance Repair at 1-888-975-0179 where our licensed and insured technicians will be happy to be of assistance.